High-density EPS insulation for tile installation

This category is intended for the installation of tiles on Adam Matériaux High-Density (HD) EPS

Requirement to apply the first layer of Adam Materiaux white adhesive, incorporating the Adam Materiaux 145-gram mesh, followed by the application of the second layer of Adam Materiaux white adhesive, using the "wet-on-wet" method, incorporating a second layer of Adam Materiaux 145-gram mesh into the second layer of Adam Materiaux adhesive, ensuring that the Adam Matériaux mesh is laid in a crisscross pattern

NOTE: The "wet-on-wet" technique may vary depending on weather conditions

During hot, dry weather, this should be done on the same day or the next day; during cold, wet weather, it should be done the next day or later, depending on the humidity level. During cold, wet weather, this must be assessed on a case-by-case basis and under the contractor’s responsibility.

It is mandatory to install 8 anchors per square meter with steel rods, such as the Wret-Met LMX-10 model

It is essential to use a C2T adhesive that complies with the EN-12004 standard when installing tiles