High-density EPS insulation for tile installation

This category is intended for laying tiles on High Density EPS (HD) Adam Matériaux

The first coat of Adam Materiaux white adhesive must be applied, incorporating the 145-gram Adam Materiaux mesh. Then, the second coat of Adam Materiaux white adhesive must be applied using the "wet-on-wet" method, incorporating a second layer of the 145-gram Adam Materiaux mesh into the first coat of Adam Matériaux , ensuring that the mesh is overlapped

WARNING: The "Wet-on-Wet" principle may vary depending on weather conditions

During hot, dry periods, it will be the same day or the following day, and during cold, humid periods, it must be the following day or later depending on the humidity level. During cold, humid periods, this must be checked on a case-by-case basis and is the responsibility of the contractor

The installation of 8 anchors/m² with steel rods is mandatory, type Wret-Met LMX-10

It is essential to use a C2T adhesive conforming to the EN-12004 standard for gluing the tiles